The main function of valves is to isolate equipment and pipeline systems, regulate flow, prevent backflow, regulate and discharge pressure. They are control components in fluid pipeline systems and play a significant role. Therefore, it is necessary to pay attention to the maintenance and upkeep of valves during normal use. Below, we will introduce the daily maintenance methods for valves.
1, Daily maintenance work of valves
1. Attention should be paid to the storage environment of valves, which should be stored in a dry and ventilated room, and the two ends of the passage should be blocked.
2. Valves should be regularly inspected and cleaned of dirt, and rust proof oil should be applied to their surface.
3. After installation, the valve should be regularly inspected to ensure its normal operation.
4. The valve sealing surface should be checked for wear and repaired or replaced according to the situation.
5. Check the trapezoidal thread wear of the valve stem and valve stem nut, whether the packing is outdated or ineffective, and make necessary replacements.
6. The sealing performance of the valve should be tested to ensure its performance.
7. The valve in operation should be intact, the bolts on the flange and bracket should be complete, the threads should be intact, and there should be no looseness.
8. If the handwheel is lost, it should be promptly equipped and cannot be replaced with an adjustable wrench.
9. The packing gland is not allowed to be skewed or have no pre tightening gap.
10. If the valve is used in a harsh environment and is easily contaminated by dirt such as rain, snow, dust, and sandstorms, a protective cover should be installed on the valve stem.
11. The ruler on the valve should be kept complete, accurate, and clear, as well as the lead seal and cap of the valve.
12. The insulation jacket should be free of dents and cracks.
13. During operation, avoid hitting or supporting heavy objects on the valve.
2, Maintenance work during valve grease injection
The professional maintenance work of valves before welding and after production plays a crucial role in serving the production and operation of valves. Correct, orderly and effective maintenance will protect valves, enable them to function normally and extend their service life. Valve maintenance work may seem simple, but it is not. There are often overlooked aspects in work.
Firstly, when injecting grease into valves, the issue of the amount of grease injected is often overlooked.
After refueling the grease gun, the operator selects the valve and grease connection method before proceeding with the grease injection operation. There are two situations: on the one hand, the amount of grease injected is insufficient, and the sealing surface wears faster due to the lack of lubricant. On the other hand, excessive fat injection leads to waste. It is because there is no precise calculation of the sealing capacity of different valves based on their type categories. The sealing capacity can be calculated based on the valve size and type, and then an appropriate amount of lubricating grease can be injected reasonably.
Secondly, when injecting grease into valves, pressure issues are often overlooked.
During the liposuction operation, the liposuction pressure exhibits regular peaks and valleys. Low pressure, seal leakage or failure. High pressure may cause blockage of the grease injection port, hardening of the grease inside the seal, or locking of the sealing ring with the valve ball or valve plate. When the grease injection pressure is usually too low, the injected lubricating grease tends to flow into the bottom of the valve chamber, usually occurring in small gate valves. If the injection pressure is too high, on the one hand, check the injection nozzle, and if the grease hole is blocked, determine the situation and replace it; On the other hand, lipid hardening requires the use of cleaning solution to repeatedly soften failed sealing grease and inject new lubricating grease for replacement. In addition, the sealing model and sealing material also affect the grease injection pressure. Different sealing forms have different grease injection pressures, and in general, the grease injection pressure for hard seals is higher than that for soft seals.
