Selection criteria
Pressure and nominal pressure
When selecting a gas safety valve, the nominal pressure of the safety valve should be determined based on the operating pressure of the system. The nominal pressure should be greater than or equal to the maximum operating pressure of the system to ensure that the safety valve can withstand the working pressure of the system.
Temperature and operating temperature range
The appropriate safety valve should be selected based on the operating temperature of the system to ensure that it can function properly as a safety protection in the corresponding temperature environment.
Displacement and medium type
It is necessary to comprehensively consider factors such as the type of medium and the displacement of the safety valve to ensure that the safety valve can meet the system's requirements for gas emissions and ensure system safety.
Installation standards
Installation position
It should be installed vertically at a higher position on the drum or manifold, and no outlet pipe or valve for steam should be installed between the safety valve and the drum or manifold.
When there are gas and liquid two-phase materials in the container, the safety valve should be installed in the gas phase section; If the safety valve is used to release flammable liquids, its outlet should be connected to the accident storage tank.
Connecting pipe cross-sectional area
The cross-sectional area of the connecting pipe between the safety valve and the boiler should not be less than the inlet cross-sectional area of the safety valve. If several safety valves are installed together on a short pipe directly connected to the drum, the cross-sectional area of the short pipe should not be less than the sum of the exhaust areas of all safety valves.
Operation and maintenance standards
Cleaning requirements
The safety valve should be kept clean to prevent the valve body, spring and other components from being blocked or corroded by oil and dirt, and to prevent the discharge pipe from being blocked by foreign objects.
Debugging requirements
After cleaning the safety valve, it must be re debugged. It is recommended to use light oil cleaning agents for cleaning.
Inspection requirements
The spring type liquefied gas safety valve of the new equipment needs to be calibrated by the local boiler inspection institute before installation and use. The closed type liquefied gas safety valve in use needs to be calibrated once or twice a year.
Related standards for outdoor gas valve chambers
Drying and anti fouling
Outdoor gas valve chambers are generally installed overhead, and the valve chamber should be kept dry to avoid contamination. Especially in areas with high air humidity, measures should be taken to cool the valve chamber to prevent water vapor from sublimating and forming droplets, which can corrode pipelines and components.
Valve Management
The gas valve must be in a locked state, and only personnel from the gas company can open it. Valves should adopt explosion-proof design, and explosion-proof plates or isolation pipes should be installed around the valve to reduce the occurrence of accidents.
electrostatic protection
Corresponding measures should be taken to reduce the generation of static electricity, such as laying conductive floor mats, setting ground wires, etc., to prevent static electricity accumulation from causing fires or explosions in valve chambers.
Pipeline inspection
The gas pipeline inside the valve chamber needs to be regularly inspected to ensure its connection reliability. If copper pipes are connected to hardware equipment such as valves, strict anti loosening measures must be taken according to regulations to ensure the corrosion resistance and stability of the fixed parts.
Environmental requirements
Outdoor gas valve chambers should be built in well ventilated areas, and the surrounding environment should be regularly inspected to ensure compliance with the valve chamber's usage standards. The construction of valve chambers should take into account harsh environmental conditions, ensure equipment corrosion resistance and cold resistance, and take corresponding measures for maintenance.
Identification settings
Set up signs at the entrance and exit of the valve chamber to indicate its purpose and attributes, clarify the type, location, and color requirements of the identification, and play a role in clarifying its function, facilitating management, and monitoring.
