Structural Characteristics And Operating Principles Of Hydraulic Control Valves

Jun 05, 2025

Leave a message

1. Structural characteristics

Hydraulic control valves are generally divided into two categories: diaphragm type and piston type, both of which have the same working principle. They are composed of a main valve (as shown in Figure 1.2) and its external needle valve, guide valve, conduit, pressure gauge, etc. And evolved into remote control float valves, pressure reducing valves, slow closing check valves, flow control valves, pressure relief/holding valves, hydraulic electric control valves, fixed water level valves, water pump control valves, emergency shut-off valves, etc., depending on the purpose, function, and location of use.

 

2. Action principle

The hydraulic control valve is powered by the pressure difference △ P upstream and downstream, and automatically adjusts to fully open or simultaneously close the main valve disc, or to be in a regulating state.

Fully closed state: When the water pressure at the inlet end of the main valve enters the valve body and control chamber respectively, and the ball valve outside the main valve is closed at the same time, the main valve is in a fully closed state,

Fully open state: When the external ball valve of the main valve is fully opened, the water pressure in the control room is completely discharged to the atmosphere or downstream low-pressure area, and the main valve is in a fully open state,

Floating state: Adjust the opening of the ball valve outside the main valve to balance the water flow between the needle valve and the ball valve. At this point, the main valve is in a floating state.

Send Inquiry